· In part two they are trying to tell you to do this: 1. Install the first nut and tighten it to 50 lb ft while spinning the hub by hand to seat the bearings properly. 2. Back the nut off 1//4 turn. 3. Install the indexing washer (the piece with all the holes and the tab on it) and align one of the holes with the nipple that sticks out on the nut. · Original Warn Locking Hub Instructions / Manual. This is probably a long shot, but I'm hoping someone has an original copy of this document that came with the vintage Warn locking hubs. Here's a photo of the installation instructions / owner's manual with a set of WL-2 or M2 locking hubs. The sheet folded down to about 3" x 3". To obtain any warranty service, you must provide WARN with proof of purchase and date of purchase acceptable to WARN, such as a copy of your purchase receipt. This warranty does not cover the removal or reinstallation of the hub. WARN will, at its option, repair, replace or refund the purchase price of a defective hub or component.
How To Replace Your Manual Locking Hubs in 8 Steps. Step 1. Use a 9/inch hex bit to remove the six socket-head hub screws that hold the OEM manual locking hub's cap in place. Step 2: Remove the cap to expose the locking hub assembly. Step 3: Use the blade of a small screwdriver to lift up the exposed end of the spring-like retaining ring. Original Warn Locking Hub Instructions / Manual. This is probably a long shot, but I'm hoping someone has an original copy of this document that came with the vintage Warn locking hubs. Here's a photo of the installation instructions / owner's manual with a set of WL-2 or M2 locking hubs. The sheet folded down to about 3" x 3". Warn Hubs are warranted directly to the first purchaseof the locking hub set; that they will be free from defects in material and workmanshipunder normal use and service for as long as said purchaser owns the locking hubs.
Step 1. Use a 9/inch hex bit to remove the six socket-head hub screws that hold the OEM manual locking hub’s cap in Step 2: Remove the cap to expose the locking hub assembly. Step 3: Use the blade of a small screwdriver to lift up the exposed end of the spring-like retaining ring. Pull the. To obtain any warranty service, you must provide WARN with proof of purchase and date of purchase acceptable to WARN, such as a copy of your purchase receipt. This warranty does not cover the removal or reinstallation of the hub. WARN will, at its option, repair, replace or refund the purchase price of a defective hub or component. Repeat step with the right wheel hub. Service Instructions. Service Kits are available. Hubs should be serviced at thesame interval as the wheel bearings. Remove in reverse order of Installation procedure(III). Then clean and lightly grease internal working surfaces. Do Not Pack theHubs with Grease, the Hubs will NOT Function Properly. Maintenance.
0コメント